FAQ: How To Sew A Stripe Down Pants?

Try This Trend: No-Sew DIY Side-Stripe Pants

Today’s project is for DIY side-stripe pants, which Emma found for $5 at a thrift store and spent less than $10 on the rest of the supplies, for a total cost of under $15 (including the price of the jeans).

Materials and Tools

1 inch wide velvet ribbon (2-3 yards depending on how long your pants are) heat bond iron-on adhesive tape (1/2 inch to 3/4 inch wide) 1 thin scrap piece of cloth iron

Instructions for Side-Stripe Pants Project

Lay your pants out flat and pin iron-on tape and velvet to the pant leg. Press the iron down on top according to the instructions on the packaging. Hem tape and velvet ribbon are perfect for side-striped pants. Just be aware that you may have to leave heat on a section for a little longer than it says on the packaging.

How do you sew striped pants?

Tutorial for Striped Pants

  1. Sew pocket piece to the body of the pants.
  2. Iron pocket outwards.
  3. Sew sides of pants together, following the outer edge of the pocket.
  4. Iron seams open on sides of pants.
  5. Sew crotch together in the front, leaving the back crotch seam open.

How do you put stripes on fabric?

You could make any size stripes you want, but less fabric paint is generally better (keeps the garment from feeling too crunchy), so narrow stripes might be your best bet. I used masking tape to create my stripes u2013 I simply placed rows of masking tape across each pattern piece about 1/4 inch apart. You could make any size stripes you want, but less fabric paint is generally better (keeps the garment from feeling too crunchy), so narrow stripes might be your best bet.

We recommend reading:  Mac How To Knit Pictures Together?

What order do you sew pants together?

Stay-stitching, seam finishes (if necessary), darts, inner and side leg seams, crotch seam, zipper, waistband, and hems will be sewn in the following order: stay-stitching, seam finishes (if necessary), darts, inner and side leg seams, crotch seam, zipper, waistband, and hems.

How do you put a side panel on pants?

Fold the top to match the length of the waistband and set a crease in the fabric with the iron. Lay the fabric so the right side of the side panel matches the right side of the pants.

How do you style striped palazzo pants?

Wear it with a black top and a nice cropped jacket, a fitted denim shirt, or a tank top over a long cardigan; the striped palazzo pants can be worn in a variety of ways.

How do you paint a sweater?

Place a few pieces of newspaper inside your sweater before painting to prevent paint from bleeding through, and then paint your design with a foam brush, slightly dampening your brush and dabbing the paint in place. Let your design dry for a few hours.

How do you draft a pants pattern like a pro?

2.1 Draw a rough outline of the pants pattern.

  1. Use half of the hips measurement (or 2 times 1/4 hips) from point A to point B, and the overall length from point B to C and A to D.
  2. Divide the rectangle in half to get two 1/4 hip wide panels, and mark the points that cross the horizontal lines as 1 and 2.

How do you sew a pants pattern?

Sewing the Pants (Part 3 of 3)

  1. Pin the pattern pieces together.
  2. Sew up each pant leg with a straight stitch 1/2″ from the edge of the fabric.
  3. Remove the pins and press all seams open with your iron.
  4. Join the two pant legs together.

Leave a Reply

Your email address will not be published. Required fields are marked *